Instructions / Assembly

2
3
4
"
REAR PANEL SLAT SPACING
"
216
" 2
"
8
1
11
9
17
1
2
1
8
"
MAKE THIS SLAT FLUSH
TO THE END OF
THE 2 X 4 X 14" BOTTOM
PANEL BOARD. SPACE
THE NEXT SLAT EQUALLY
BETWEEN THE FIRST SLAT
AND THE CORNER
POST.
1: FIND TWENTY-TWO 5/4 X 2-5/8 X 28-1/4" PANEL SLATS.
2: PRE-DRILL THE SLATS 1" FROM EACH END ON CENTER WITH A 1/8" DRILL BIT.
3: INSTALL THE PANEL SLATS AT EQUAL LENGTHS. SEE DETAIL BELOW FOR MEASUREMENTS.
4: ATTACH THE PANEL SLATS TO THE FORT WITH 2" WOOD SCREWS IN THE PRE-DRILLED HOLES.
ROCK WALL SIDE PANEL
SWING BEAM PANEL
SLAT DIMENSIONS
(VIEW FROM OUTSIDE
THE PLAY SET.)
STEP 22: PANEL SLATS
PANEL SLAT
5/4 X 2-5/8 X 28-1/4"
SCREW
2" WOOD
LEAVE THIS SLAT OFF UNTIL AFTER
INSTALLING THE TIRE SWING
BEAM. ONCE THE TIRE SWING
BEAM IS IN PLACE SECURE THIS
SLAT FLUSH TO THE SIDE OF THE
SWING BEAM.
SWING BEAM
PANEL
FRONT PANEL SLATS
ARE INSTALLED FLUSH
TO THE NOTCH ON
THE FRONT FACE
BOARD.
REAR PANEL
ROCK WALL
PANEL
57