Instructions / Assembly

STEP 57: TARP (UPPER LEVEL)

SIDE. (NOTE IF YOU WISH YOU MAY PREDRILL HOLES FOR THE PAN HEAD SCREW WITH A 1/8" DRILL BIT.)

3: NOW FOLD THE FLAP UNDER THE TARP BOARD AND FASTEN THE GROMMETS UNDER THE TARP BOARD WITH #14

X 1-1/4" PAN HEAD SCREWS WITH 1/4" WASHERS. REPEAT FOR OTHER SIDE. ( NOTE IF YOU WISH YOU MAY

PREDRILL HOLES FOR THE PAN HEAD SCREWS WITH A 1/8" DRILL BIT.)

THE TARP TO THE TARP BOARD WITH #14 X 1-1/4" PAN HEAD SCREWS WITH 1/4" WASHERS. REPEAT FOR OTHER

2: FASTEN THE OUTSIDE CORNERS OF THE TARP TO THE SIDE OF THE TARP BOARD FIRST. ATTACH THE GROMMETS IN

1: PLACE THE TARP (UPPER LEVEL) ACROSS THE TARP BOARDS (UPPER LEVEL) WITH THE HEMS ON THE INSIDE.

NOTE: IF YOU WISH

YOU MAY DRILL

1/8" PILOT HOLES IN THE

TARP BOARD FOR THE

PAN HEAD SCREWS.

AND 1/4" WASHERS.

REPEAT FOR OTHER SIDE.

DETAIL A

PAN HEAD SCREWS

THEN FOLD

THIS TAB UNDER

THE TARP BOARD

AND SECURE IT TO

THE BOTTOM

SIDE OF THE TARP

BOARD WITH

#14 X 1-1/4"

FASTEN OUTSIDE GROMMETS FIRST TO

THE SIDE OF THE TARP BOARD ON

EACH SIDE WITH #14 X 1-1/4"

PAN HEAD SCREWS AND 1/4" WASHERS.

REPEAT FOR OTHER SIDE.

TARP