Instructions / Assembly

2 X 4 X 70"
UPPER LEVEL STEP
4 X 4 X 43-1/2"
3/8" WASHER
DRILL 3/8" HOLE
RAD RIDE CENTER POST
2" WOOD SCREW
5/4 X 4 X 25"
RAD RIDE DECK
UPPER LEVEL
LAG SCREW UNDER DECK SUPPORT
SPACER
4 X 4 X 70"
(FROM OTHER SIDE)
3/8 X 5"
AT THIS LOCATION
5/16" WASHER
5/16 X 4-1/2"
HEX BOLT
T-NUT
RAILING/
TOP OPENING SAME
AS BOTTOM & DRILL HOLE
(THIRD)
STEP 38: ATTACHING RAD RIDE CENTER POST
1: LEVEL THE 5/4 X 4 X 25" RAD RIDE DECK SPACER TO THE DECK BOARD AND FLUSH THE END TO THE REAR CORNER
POST. USE 2" WOOD SCREWS TO ATTACH IT TO THE DECK SUPPORT .
2: MAKE THE DECK SPACER LEVEL TO DECK BOARD. USE A 3/8 X 5" LAG SCREW AND WASHER TO ATTACH THE
CENTER POST TO THE UPPER LEVEL UNDER DECK SUPPORT.
3: MAKE SURE THE LOWER LEVEL FRONT CENTER POST IS SQUARE TO THE DECK.
4: MEASURE THE BOTTOM OPENING AND RECORD THIS MEASUREMENT. MEASURE AT THE TOP OF THE OPENING.
MAKE THE TOP OF THE OPENING THE SAME AS THE MEASUREMENT YOU RECORDED. NOW USE THE TOP HOLE IN THE
RAD RIDE CENTER POST TO DRILL A 3/8" HOLE THROUGH THE 2 X 4 X 70" RAILING.
5: INSTALL A T-NUT INTO THE HOLE YOU JUST DRILLED FROM THE INSIDE OF 2 X 4 X 70" RAILING/UPPER LEVEL STEP.
6: USE A 5/16 X 4-1/2" HEX BOLT WITH A 5/16" WASHER TO FASTEN THE RAILING/UPPER LEVEL STEP TO THE RAD RIDE
CENTER POST.
78