Instructions / Assembly

DETAIL A
SCALE 1 : 8
2"
3
1
2
"
2-1/2"
WOOD
SCREW
3"
WOOD
SCREW
1: Place a 5/16” Tee Nut into the hole in the Fort Supports as shown.
2: From the inside of the Right Panel Board loosely attach each Fort Support with one 5/16” x
2-1/2” Hex Bolt and one 5/16” washer.
3: Measure 2” and 3-1/2” down from the tip of each Fort Support and drill a 1/8” hole through
the Fort Support along the center. (See Detail A)
4: Place each Fort Support against the Corner Post. The side of the Fort Support should be
flush with the right side of the Right Corner posts.
5: Attach the angled end of each Fort Support with one 2-1/2” Wood Screw and one 3”
Wood Screw. Tighten each 5/16” x 2-1/2” Hex Bolt.
STEP 8: FORT SUPPORTS
A
RIGHT
PANEL
BOARD
5/16"
TEE NUT
2 X 4 X 48"
FORT SUPPORT
2 X 4 X 48"
FORT SUPPORT
5/16"
WASHER
5/16" X 2-1/2"
HEX BOLT
5/16"
X 2-1/2"
HEX BOLT
5/16"
WASHER
5/16"
TEE NUT
37