Instructions / Assembly

RIGHT SIDE OF PLAY SET

COUNTER-SUNK

HOLES FACE OUT

COUNTER-SUNK

HOLES FACE DOWN

4 X 4 X 47-3/8"

SWING BEAM SUPPORT

CARRIAGE BOLT

3/8" LOCK NUT

SCALE 1 : 8

DETAIL A

TORQUE WASHER

3/8" WASHER

3/8" X 6-1/2"

BOLT CAP

THIS HOLE IS TO BE

USED ONLY IF YOUR

YARD RUNS UP-HILL.

IF INSTALLING YOUR

PLAY SET ON

RELATIVELY LEVEL

GROUND THEN THIS

HOLE WILL NOT BE

USED.

STEP 25: SWING BEAM SUPPORT

1. The 4 x 4 x 47-3/8” Swing Beam Support has counter-sunk holes in the center and on the

ends. Install the Swing Beam Support so that the counter-sunk holes on each end of the

beam face out, and the counter-sunk holes in the center face down.

2. Fasten the Swing Beam Support to the right corner posts using 3/8” x 6-1/2” carriage bolts

and torque washers. Place the carriage bolt into the torque washer, then into the hole of the

corner post and set with a hammer. Use 3/8” lock nuts and 3/8” washers to secure the Swing

Beam Support from the outside. Place bolt caps over the exposed threads after securing.

Note: There are two mounting positions for the Swing Beam Support. Use the lower holes in

the right corner posts if your yard is relatively flat. Stand with your back against the right of

the play set. If your yard runs uphill then you should use the upper holes in the right corner

posts.