Instructions / Assembly

3/8" X 3-1/2"

CARRIAGE

BOLTS

SWING

BEAM

PLATE

1: Place the Swing Beam Plate on top of the Swing Beam Support, lining up the pilot holes.

2: Fasten the Swing Beam Plate to the Swing Beam Support on the outside holes using 3/8” x

3-1/2” carriage bolts from the top and 3/8” washers with 3/8” lock nuts on the bottom. Place

bolt caps over exposed threads after securing.

3: Leave the middle hole empty, it will be used later.

STEP 26: SWING BEAM PLATE

3/8" WASHER

3/8" LOCK NUT

BOLT

CAP