Instructions / Assembly

3/8" WASHER

3/8" X 3-1/2"

LAG SCREW

BOLT CAP

3/8" LOCK NUT

SWING BEAM

PLATE

SWING BEAM

TORQUE WASHER

3/8 X 9" CARRIAGE BOLT

*An extra person is required for this step.

1: Have one person line up the hole in the end of the Swing Beam with the middle hole on

the Swing Beam plate. The other person may have to carry the other end where the legs are

located to accomplish this task.

2: Fasten the Swing Beam to the Swing Beam Plate and Swing Beam Support using a 9”

carriage bolt with a torque washer on top and a 3/8” lock nut and washer on the bottom.

Place green bolt caps over exposed threads after securing.

3: Fasten the Swing Beam to the Swing Beam Plate from underneath with a 3/8” x 3-1/2” lag

screw and a 3/8” washer.

STEP 31: SWING BEAM TO FORT