Instructions / Assembly

DETAIL A

3/8" x 5-1/2"

Lag Screw

3/8" Washer

1880E

MONKEY BAR SUPPORT

FLUSH

STEP 10: MONKEY BAR SUPPORT

1: PLACE THE MONKEY BAR SUPPORT ON TOP OF THE ARCH BOARD.

2: PLACE THE LAG SCREWS IN THE HOLES AND HAMMER THEM TO LEAVE MARKS ON THE

CORNER POSTS.

3: REMOVE THE MONKEY BAR SUPPORT AND THE LAG SCREWS. DRILL 11/64" HOLES AT

EACH OF THE MARKS BY 2-1/2" DEEP.

4: PLACE THE MONKEY BAR SUPPORT BACK INTO PLACE ON TOP OF THE ARCH BOARD

AND FASTEN AS SHOWN BELOW.