Installation & Assembly
Table Of Contents
- 11-0011 - 701 - Hardware REV B
- 11-0012 - 703 - Hardware REV B
- 701 - Lumber - 2014
- 703 - Lumber - 2014
- 703 - Accessories - 2013
- 703 Steps 2_2014
- 701 - 01 (new)
- 701 - 02 (NEW)
- 701 - 03 (NEW)
- 701 - 04
- 701 - 05
- 701 - 06
- 701 - 07
- 701 - 08
- 703 - 09
- 703 - 10
- 701 - 11
- 703 - 12
- 703 - 13
- 703 - 14
- 703 - 15
- 701 - 16
- 703 - 17
- 703 - 18
- 701 - 19
- 703 - 20
- 703 - 21
- 703 - 22
- 701 - 23
- 701 - 24
- 701 - 25
- 701 - 26
- 701 - 27
- 701 - 28
- 701 - 29 NEW
- 701 - 30 NEW
- 701 - 31
- 701 - 32
- 701 - 33
- 701 - 34
- 701 - 35
- 701 - 36
- 703 - 37
- 703 - 38
- 703 - 39
- 703 - 40
- 703 - 41
- 703 - 42
- 703 - 43
- 703 - 44
- 703 - 45
- 703 - 46
- 703 - 47
- 703 - 48
- 703 - 49
- 703 - 50
- 703 - 51
- 703 - 52
- 703 - 53
- 703 - 54
- 703 - 55 - Sheet1
4 X 4 X 70"
TIRE SWING SUPPORT
VIEW FROM THE BOTTOM OF THE FORT
3/8" WASHER
SUPPORT BOARD
THIS BOARD
ROCK WALL
2 X 4 X 58"
USE 2" WOOD SCREWS
WHEN INSTALLING
3/8 X 5" LAG SCREW
SEE IMAGE BELOW FOR LOCATION OF THE CENTER
DECK SUPPORT
STEP 23: CENTER DECK SUPPORTS
1: FIND THE 4 X 4 X 70" TIRE SWING SUPPORT, AND ARRANGE EVENLY UNDERNEATH THE DECK.
2: ATTACH THE TIRE SWING SUPPORT WITH A 3/8 X 5" LAG SCREW AND A 3/8" WASHER THROUGH THE LADDER
CENTER. FROM THE TOP, ADD TWO 2-1/2" WOOD SCREWS THROUGH THE DECK BOARDS, INTO THE CENTER DECK
SUPPORT.
3: FIND THE 2 X 4 X 58" ROCK WALL SUPPORT BOARD, AND CENTER IT ON THE BACK OF THE ROCK WALL. MAKE
SURE THAT THE HOLE IN THE BOTTOM ROCK WALL BOARD IS NOT OBSTRUCTED BY THE ROCK WALL SUPPORT
BOARD.
4: THE ROCK WALL SUPPORT BOARD WILL ATTACH TO THE ROCK WALL WITH TWO 2" WOOD SCREWS PER END,
AND AN ADDITIONAL 2" WOOD SCREW IN THE MIDDLE OF THE ROCK WALL SUPPORT BOARD AT EACH ROCK
WALL BOARD. FROM THE FRONT OF THE ROCK WALL, ADD TWO 2" WOOD SCREWS THROUGH THE ROCK WALL
BOARDS, INTO THE ROCK WALL SUPPORT BOARD.
52