Installation & Assembly
Table Of Contents
- 11-0011 - 701 - Hardware REV B
- 11-0012 - 703 - Hardware REV B
- 701 - Lumber - 2014
- 703 - Lumber - 2014
- 703 - Accessories - 2013
- 703 Steps 2_2014
- 701 - 01 (new)
- 701 - 02 (NEW)
- 701 - 03 (NEW)
- 701 - 04
- 701 - 05
- 701 - 06
- 701 - 07
- 701 - 08
- 703 - 09
- 703 - 10
- 701 - 11
- 703 - 12
- 703 - 13
- 703 - 14
- 703 - 15
- 701 - 16
- 703 - 17
- 703 - 18
- 701 - 19
- 703 - 20
- 703 - 21
- 703 - 22
- 701 - 23
- 701 - 24
- 701 - 25
- 701 - 26
- 701 - 27
- 701 - 28
- 701 - 29 NEW
- 701 - 30 NEW
- 701 - 31
- 701 - 32
- 701 - 33
- 701 - 34
- 701 - 35
- 701 - 36
- 703 - 37
- 703 - 38
- 703 - 39
- 703 - 40
- 703 - 41
- 703 - 42
- 703 - 43
- 703 - 44
- 703 - 45
- 703 - 46
- 703 - 47
- 703 - 48
- 703 - 49
- 703 - 50
- 703 - 51
- 703 - 52
- 703 - 53
- 703 - 54
- 703 - 55 - Sheet1
STEP 34: ROPE LADDER ASSEMBLY
4: MEASURE 19" FROM THE TOP OF THE ROPE LADDER RUNG ON THE ROPE AND MARK THIS
LOCATION. MAKE SURE THE BOARD IS RESTING AGAINST THE PREVIOUS KNOT THAT WAS TIED
WHEN MEASURING.
5: TIE A KNOT BELOW THE MARK THAT WAS MADE AND THREAD THE ROPE THROUGH THE
HOLES IN THE NEXT ROPE LADDER RUNG. THERE SHOULD BE APPROXIMATELY A 10" GAP
BETWEEN THE BOARDS.
6: CONTINUE THIS PROCESS UP THE ROPE, AND WHEN THE LAST BOARD HAS BEEN PLACED, TIE
A KNOT DIRECTLY ABOVE IT. THE LAST BOARD TIED WILL BE THE TOP OF THE ROPE LADDER.
1: FIND THE THREE ROPE LADDER ROPES OF EQUAL LENGTH. MEASURE 30" FROM ONE SIDE OF
EACH PIECE OF ROPE AND MAKE A MARK AT THIS LOCATION.
2: TIE A KNOT ON THE OTHER SIDE OF THE ROPE THAT IS JUST ABOVE THE MARK THAT WAS
MADE ON THE ROPE (SEE BELOW).
3: THREAD THE ROPE THROUGH THE HOLES OF THE 2 X 4 ROPE LADDER RUNG. YOU MAY NEED
TO TWIST THE ROPE TO GET IT THROUGH.
MARK THE LOCATION AT 30"
TIE KNOT JUST ABOVE THE MARK AT 30"
RUNGS
10" BETWEEN THE
ROPE LADDER
THERE SHOULD BE
APPROXIMATELY
AFTER THE LAST BOARD IS
PLACED ON THE ROPE
LADDER ASSEMBLY, TIE A
KNOT DIRECTLY ABOVE
THE LAST BOARD
63