Installation & Assembly
Table Of Contents
- 11-0011 - 701 - Hardware REV B
- 11-0012 - 703 - Hardware REV B
- 701 - Lumber - 2014
- 703 - Lumber - 2014
- 703 - Accessories - 2013
- 703 Steps 2_2014
- 701 - 01 (new)
- 701 - 02 (NEW)
- 701 - 03 (NEW)
- 701 - 04
- 701 - 05
- 701 - 06
- 701 - 07
- 701 - 08
- 703 - 09
- 703 - 10
- 701 - 11
- 703 - 12
- 703 - 13
- 703 - 14
- 703 - 15
- 701 - 16
- 703 - 17
- 703 - 18
- 701 - 19
- 703 - 20
- 703 - 21
- 703 - 22
- 701 - 23
- 701 - 24
- 701 - 25
- 701 - 26
- 701 - 27
- 701 - 28
- 701 - 29 NEW
- 701 - 30 NEW
- 701 - 31
- 701 - 32
- 701 - 33
- 701 - 34
- 701 - 35
- 701 - 36
- 703 - 37
- 703 - 38
- 703 - 39
- 703 - 40
- 703 - 41
- 703 - 42
- 703 - 43
- 703 - 44
- 703 - 45
- 703 - 46
- 703 - 47
- 703 - 48
- 703 - 49
- 703 - 50
- 703 - 51
- 703 - 52
- 703 - 53
- 703 - 54
- 703 - 55 - Sheet1
STEP 35: INSTALLING THE ROPE LADDER
1: UNROLL THE ROPE LADDER ASSEMBLY. LOOK FOR THE BOARD THAT HAS KNOTS TIED ABOVE AND BELOW THE
ROPE LADDER STEP. THIS WILL BE THE TOP OF THE ROPE LADDER.
2: THREAD THE TOP OF THE ROPE LADDER THROUGH THE HOLES IN THE ROPE LADDER SUPPORT, AND TIE A SECURE
KNOT.
3: THREAD THE BOTTOM OF THE ROPE LADDER THROUGH THE HOLES IN THE ROPE LADDER RUNNER, AND TIE A
SECURE KNOT.
4: MAKE SURE THE ROPE LADDER ROPES WILL NOT LOOP AROUND YOUR HAND.
BOARD
TIE A KNOT BEHIND THIS
TIE A KNOT BEHIND THIS
BOARD
GRAB EACH ROPE AND ATTEMPT
TO WRAP IT AROUND YOUR
HAND. IF IT WRAPS AROUND
YOUR HAND IT IS TOO LOOSE.
UNTIE ONE END AND THEN RETIE
IT UNTIL IT NO LONGER WRAPS
AROUND YOUR HAND.
64