Owner Manual

STEERING WHEEL

STEERING WHEEL INSERT WASHER

2-1/2" LAG SCREW

STEERING WHEEL CAP

DRILL 3/16" HOLE

1" BELOW THE T-NUT.

T-NUT

STEP 45: STEERING WHEEL

1: GO TO THE REAR CENTER POST ON THE DECK.

2: DRILL A 3/16" PILOT HOLE 1" BELOW THE CENTER OF THE T-NUT. DRILL THE HOLE 2" DEEP.

3: PLACE THE STEERING WHEEL INSERT INSIDE THE STEERING WHEEL.

4: USE THE 2-1/2" LAG SCREW AND WASHER TO FASTEN THE STEERING WHEEL TO THE REAR

CENTER POST. DO NOT OVER-TIGHTEN THE LAG SCREW OR THE STEERING WHEEL WILL

NOT TURN.

5: PLACE THE STEERING WHEEL CAP OVER THE CENTER OF THE STEERING WHEEL AND

SNAP IT INTO THE STEERING WHEEL INSERT.