Owner Manual

MONKEY BAR PLATE

5/16" FLAT WASHER

5/16" X 3-1/2" HEX HEAD BOLT

NOTE: SELF TAPPING SCREWS INSTALLED IN

STEP 1 SHOULD BE ON THE BACK SIDE OF THE

LADDER.

NOTE: SELF TAPPING SCREWS INSTALLED IN

STEP 2 SHOULD BE ON THE UNDER SIDE OF THE

MONKEY BAR ASSEMBLY.

LADDER ASSEMBLY FROM STEP 1

MONKEY BAR ASSEMBLY FROM STEP 2

ATTACH OTHER

MONKEY BAR

PLATE TO THIS

SIDE

COUNTERSUNK

HOLES ON TOP.

STEP 3: ATTACHING THE LADDER TO THE

MONKEY BAR ASSEMBLY

1: LOCATE TWO 8-5/8" W X 6-1/2"H MONKEY BAR PLATES, EIGHT 5/16" X 3-1/2"L HEX BOLTS AND

EIGHT 5/16" FLAT WASHERS.

LOOSELY

ATTACH THE LADDER ASSEMBLY TO THE MONKEY BAR

ASSEMBLY WITH THE MONKEY BAR PLATES. USE 5/16" X 3-1/2"L HEX BOLTS WITH 5/16" FLAT

WASHERS TO ATTACH THE MONKEY BAR PLATES TO THE TEE NUTS PREVIOUSLY INSTALLED..

2: ONCE ALL THE HEX BOLTS ARE STARTED IN THE TEE NUTS TIGHTEN THEM DOWN.

NOTE: THE SELF TAPPING SCREWS INSTALLED IN STEPS 1 & 2 SHOULD BE FACING BACK SIDE OF

THE LADDER ASSEMBLY AND THE UNDER SIDE OF THE MONKEY BAR ASSEMBLY.