SDS

GORILLA WELD - RESIN SDS Page 10 of 20
Safety Data Sheet – Gorilla Weld - Resin
Date Revised: 02/27/2017 Version 1.1
Date Issued: 01/25/2017
FOR CHEMICAL EMERGENCY
DURING BUSINESS HOURS: [phone] | OUTSIDE BUSINESS HOURS: [phone]
According to Federal Register / Vol. 77, No. 58 / Monday, March 26, 2012 / Rules and Regulations and according to the Hazardous
Products Regulation (February 11, 2015).
Nova Scotia
OEL TWA (ppm)
10 ppm
Nunavut
OEL STEL (ppm)
15 ppm
Nunavut
OEL TWA (ppm)
10 ppm
Northwest Territories
OEL STEL (ppm)
15 ppm
Northwest Territories
OEL TWA (ppm)
10 ppm
Ontario
OEL TWA (ppm)
10 ppm
Prince Edward Island
OEL TWA (ppm)
10 ppm
Québec
VEMP (mg/m³)
49 mg/m³
Québec
VEMP (ppm)
10 ppm
Saskatchewan
OEL STEL (ppm)
15 ppm
Saskatchewan
OEL TWA (ppm)
10 ppm
Exposure Controls
Appropriate Engineering Controls: Emergency eye wash fountains and safety showers should be available in the immediate vicinity
of any potential exposure. Ensure adequate ventilation, especially in confined areas. Gas detectors should be used when flammable
gases or vapors may be released. Proper grounding procedures to avoid static electricity should be followed. Use explosion-proof
equipment. Vapors may be uninhibited and polymerize, causing blockage of vents. Ensure all national/local regulations are
observed.
Personal Protective Equipment: Gloves. Protective clothing. Protective goggles. Insufficient ventilation: wear respiratory protection.
Face shield.
Materials for Protective Clothing: Chemically resistant materials and fabrics. Wear fire/flame resistant/retardant clothing.
Hand Protection: Wear protective gloves.
Eye Protection: Chemical safety goggles and face shield.
Skin and Body Protection: Wear suitable protective clothing.
Respiratory Protection: If exposure limits are exceeded or irritation is experienced, approved respiratory protection should be worn.
In case of inadequate ventilation, oxygen deficient atmosphere, or where exposure levels are not known wear approved respiratory
protection.
Environmental Exposure Controls: Avoid release to the environment.
Other Information: When using, do not eat, drink or smoke
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
Information on Basic Physical and Chemical Properties
Physical State
:
Liquid
Appearance
:
Off-white
Odor
:
Like acrylic
Odor Threshold
:
Not available
pH
:
Not available
Evaporation Rate
:
Not available
Melting Point
:
Not available
Freezing Point
:
Not available
Boiling Point
:
100 °C (212 °F)
Flash Point
:
8.9 °C (48.02 °F) Closed Cup
Auto-ignition Temperature
:
Not available