User's Manual

8
2.3 Setup and Operation
a) Unit Setup
(1) Check unit
Please check whether the equipment is in good appearance & whether accessories are completed.
(2) Set In SIM Card
Please press out the SIM card slot and put SIM card in. Please not put SIM card in or out when the
equipment is connecting power. And please make sure the SIM card has data service.
(3) Setup Position
A. Waterproof: Please set the equipment in dry surroundings; keep it away from air conditioner vents
to prevent condensation water inside of the main unit.
B. Anti-Vibrate： tracker cannot install in where is long term vibrated
C. Anti-interference: tracker should stay away from car audio or intercom devices, to prevent
conducted and radiated interference.
(4) Connect GPS Antenna
A. Please notice that the GPS Antenna signal receiving side should up to sky and no metal block.
Bottom keep flat, tilt should not be more than 45°
B. Wires should be concealed;
C. Please make sure the GPS antenna is connected to the right connector and fixed tightening to avoid
vibrated.
(5) Connect to Car Main Power
Please connect the main unit to car main power according to the form before. Connect Red wire to
power “+”
---Car master positive power supply.
Black wire connects to Power “-” or grounding, but please ensures good conductivity of the grounding
place.