User manual

LABKON Series
_________________________________________________________________________________________________
34 GMC-I Messtechnik GmbH
SYSTem:ERRor?
*CLS
*ESE <enable value>
*ESE?
*ESR?
*OPC
*OPC?
*PSC {0|1}
*PSC?
*SRE <enable value>
*SRE?
*STB?
*WAI
4.15 RS232 Interface Commands
SYSTem
:LOCal
:REMote
:RWLock
4.16 Simplified Programming Overview
This chapter gives an overview of the basic commands used to program the power supply over the remote interface. Some of
them are the SCPI-confirmed commands, and some are the device-specific commands. It is unnecessary to differentiate
them when using GOSSEN METRAWATT LABKON Series.
4.17 Using the APPLy Command
The APPLy command provides the most straightforward method to program the power supply over the remote interface,
such as to control one output or triple outputs of power supply, and to read the immediate output value of each supply. Give
the following example to illustrate:
APPLY 3.3,2.0 Set the supply to an output of 3.3V rated at 2.0A
APLLY 12.0,0.5 Set the supply to an output of 12.0V rated at 0.5A