User manual

68 GMC-I Messtechnik GmbH
Select a new object from a list.
Select the desired object from the list with the ↑↓ keys and
acknowledge with the ↵ key.
Depending upon the profile selected in the test instrument’s
SETUP menu (see section 4.6), the number of object types may
be limited, and the hierarchy may be laid out differently.
Enter a designation.
Enter a designation and then acknowledge it by entering a ✓.
Note
Acknowledge the standard or adjusted parameters
shown below, because the created designation will oth-
erwise not be accepted and saved.
Set Electrical Circuit Parameters
For example, nominal current values must be entered here for the
selected electrical circuit. Measuring parameters which have been
accepted and saved in this way are subsequently accepted by
the current measuring menu automatically when the display is
switched from the structural view to measurement.
Note
Electrical circuit parameters changed during structure
creation are also retained for individual measurements
(measurement without saving data).
If you change the electrical circuit parameters defined in the
structure of the test instrument, a warning is issued upon
saving, see error message on page 81.
16.3.2 Searching for Structural Elements
The search always starts with database, regardless of the currently
marked object.
Go to page 3/3 in the database menu.
After selecting text search
and entering the desired text (only full matches are found – no
wild cards, case sensitive)
the first match is displayed.
Further matches can be found by selecting
the icon shown at the right.
Scroll up
Scroll down
Acknowledge selection
Select character
Select character
↵ Accept character
Delete characters
Character selection:
✓ Save object designation
A, a, 0, @
Select parameter
→ List of parameter settings
Acknowledge parameter selection
↵ Acknowledge parameter setting
and return to page 1/3
Select parameter setting
in the database menu.
Scroll up
Scroll down
Acknowledge selection /
Display object
Menu selection → page 3/3
change level
or ID number
Search for ID number
Search for text
Search for ID number or text
Select character
Select character
↵ Accept character
Delete characters
Character selection:
✓ Save object designation
Continue searching