User Manual

54 GMC-I Messtechnik GmbH
Calibration Functions: V – Hz – Ω – Temp – mA – mA
Setting the Interval Parameters
seleCt range 300 mV … 15 V   1nt
Initial value:
1nt start 02.000 V  
Final value:
1nt end 10.000 V  
Steps: 1nt steps 03.0  
Dwell time:
1nt t1 00.05 min.s  
Repetition:
1nt mode auto  manual
(Auto = automatic sequence, MAnuAL = manual sequence)
Manually Controlled Interval Sequence
After entering all parameters for the “manual interval sequence”
output function (
1nt mode = manual) and starting the function with
the
key, the individual steps are triggered with the  and  keys.
The relationship between the output signal and each of the key
operations is depicted with the help of the following example.
Example of a Manually Controlled Interval Sequence
Key
1 When 1nt
ready appears at the display
Start the sequence by pressing
2 The sequence is continued in the corresponding direction by
pressing the  or  key.
3 Stop the interval sequence by pressing the key.
ZERO/SEL
ESC
MEAS/CAL
SETUP
OUT
ENTER
OUT
ENTER
OUT
ENTER
OUT
ENTER
OUT
ENTER
OUT
ENTER
4
8
12
16
20
t[s]
I
Source
Manual Stop
[mA]
âô
ESC
ê
The time intervals depend on the operator
(they’re only identical in the automatic mode).
  
OUT
ENTER
ZERO/SEL
ESC