User Manual

GMC-I Messtechnik GmbH 57
Calibration Functions: V – Hz – Ω – Temp – mA – mA
Setting Ramp Parameters
seleCt range 300 mV … 15 V   ramp
Initial value: ramp start 02.000 V  
Final value:
ramp end 10.000 V  
Rise time:
ramp t1 00.05 min.s  
Dwell time: ramp t2 00.08 min.s  
Fall time:
ramp t3 00.05 min.s  
Repetition:
ramp mode repeat  onCe
(rEPEAT = endless loop, onCE = one-time only)
Example of a Periodic Ramp Sequence
Manually Controlled Ramp Sequence
After entering all parameters, start with .
Rising or falling ramps can be triggered with the  or  key.
The relationship between the output signal and each of the key
operations is depicted with the help of the following example.
ZERO/SEL
ESC
MEAS/CAL
SETUP
OUT
ENTER
OUT
ENTER
OUT
ENTER
OUT
ENTER
OUT
ENTER
OUT
ENTER
Start
End
t1
t2
t3
t2
Output
t
OUT
ENTER