User Manual

GMC-I Messtechnik GmbH 61
Device and Measuring Parameters
7.1 Paths to the Various Parameters 7.2 List of All Parameters
bAtt:
0CCvP:
dAtE:/
t iME:
caldat :
1tEMP:
1nFo
SEnd SET StorE
StArt
StoP
000.0
CLEAr
StArt/
StoP
Sub-Menus/Parameters ↓
tempext
tempunit
beep
rAtE
APoFF
bEEP
irStb
Addr
dAtE
tiME
Main Menus →
Query Set Set Set
OUT
ENTER
OUT
ENTER
OUT
ENTER
OUT
ENTER
1nfo
MEAS / CAL
SETUP
020 . 00
V
DC
AC
TRMS
Acknowledge
OUT
ENTER
Acknowledge
OUT
ENTER
Acknowledge
OUT
ENTER
Parameter
Page: Header
0.diSP
62: 0.diSP – show/hide leading zeros
Addr
67: Configuring Interface Parameters
APoFF
63: APoFF – specified time for automatic shutdown and continuous ON
bAtt
62: bAtt – query battery voltage
bEEP
63: bEEP – set limit value for continuity testing
caldat
62: cALdAt – query calibration date
CLEAr
23: Measurement Data Recording
CLAMP
41: Direct Current Measurement with Current Clamp Sensor, mA DC
42: AC Measurement with Current Clamp Sensor, A AC and Hz
43: Direct and Alternating Current Measurement with Current Clamp Trans-
former, mA DC, mA AC and Hz
dAtE
62: query date and time
64: dAtE – enter date
EMpty
23: Measurement Data Recording
1nfo
62: Querying Parameters – InFo Menu (as moving letters)
irStb
67: Configuring Interface Parameters
1tEMP
62: ItEMP – query reference temperature
0CCvP
23: Measurement Data Recording
rAtE
62: rAtE – set the sampling rate
SEnd
66: Activating the Interface
SET
62: Entering Parameters – SETUP Menu
StArt
23: Measurement Data Recording
StoP
store
tEMP
34: Temperature Measurement
t iME
62: querying date and time,
64: tiME – set time