User Manual

62 GMC-I Messtechnik GmbH
Device and Measuring Parameters
7.3 Querying Parameters – InFo Menu (as moving letters)
bAtt – query battery voltage
1nFo bAtt: 3.1 V.
OCCUP – query memory occupancy
1nFo bAtt:  ...  0CCvP: 000.0 %
querying date and time
1nFo bAtt:
 ...  31 . 12 . 2009 (DD.MM.YYYY)
t iME:
13:46:56 (hh:mm:ss)
D = day, M = month, Y = year, h = hour, m = minute, s = second
Date and time must be reentered after replacing the batteries.
cALdAt – query calibration date
1nFo bAtt:
 caldat: 06.07.09 ver2.00
ItEMP – query reference temperature
The temperature of the internal reference junction is measured with a
temperature sensor in close proximity to the input sockets.
1nFo bAtt:  ...  1tEMP: 24 °C
7.4 Entering Parameters – SETUP Menu
rAtE – set the sampling rate
The sampling rate specifies the time interval after which the
respective measured value is transmitted to the interface, or to
measured value memory.
Any one of the following sampling rates can be selected:
[mm:ss.t] 00:00.1, 00:00.2, 00:00.5, 00:01.0, 00:02.0, 00:05.0
[h:mm:ss.z] (h=hours, m=minutes, s=seconds
, z=tenths of a sec. )
0:00:10, 0:00:20, 0:00:30, 0:00:40, 0:00:50, 0:01:00, 0:02:00,
0:05:00, 0:10:00, 0:20:00, 0:30:00, 0:40:00, 0:50:00, 1:00:00,
2:00:00, 3:00:00, 4:00:00, 5:00:00, 6:00:00, 7:00:00, 8:00:00,
9:00:00
Setting the Sampling Rate
1nFo  ...  SET time  ...  rAtE
00:00.1 ... 00:00.5 ... 9:00:00 
(00:00.5 = 0.5 s = default value)
0.diSP – show/hide leading zeros
This parameter determines whether or not leading zeros will
appear in the measured value display.
1nFo  ...  SET time  ...  0.diSP
0000.0 : with leading zeros (default value)
0.0 : leading zeros suppressed

MEAS / CAL
SETUP
OUT
ENTER
MEAS / CAL
SETUP
OUT
ENTER
MEAS / CAL
SETUP
OUT
ENTER
MEAS / CAL
SETUP
OUT
ENTER
MEAS / CAL
SETUP
OUT
ENTER
MEAS / CAL
SETUP
OUT
ENTER
OUT
ENTER
OUT
ENTER
MEAS / CAL
SETUP
OUT
ENTER
OUT
ENTER
OUT
ENTER