User Manual

64 GMC-I Messtechnik GmbH
Device and Measuring Parameters
tiME – set time
Entering the correct time makes it possible to acquire measured
values in real-time.
1nFo
 ...  SET time  ...  t iME
10:24:30 (hh:mm:ss)
 
Date and time must be reentered after replacing the batteries.
dAtE – enter date
Entering the current date makes it possible to acquire measured
values in real-time.
1nFo  ...  SET time  ...  dAtE
31.12 (DD: day . MM: month)  
2005 (YYYY: year)
 
Date and time must be reentered after replacing the batteries.
7.5 Default Settings
Previously entered changes can be undone, and the default
settings can be reactivated. This may be advisable under the
following circumstances:
• After the occurrence of software or hardware errors
• If you are under the impression that the multimeter does not
work correctly
Ð Disconnect the device from the measuring circuit.
Ð Remove the batteries temporarily (see also section 10.2).
Ð Simultaneously press and hold the and
keys, and connect the battery at the same time.
MEAS / CAL
SETUP
OUT
ENTER
OUT
ENTER
OUT
ENTER
MEAS / CAL
SETUP
OUT
ENTER
OUT
ENTER
OUT
ENTER
OUT
ENTER
ZERO / SEL
ESC
ON / OFF
LIGHT