User Manual

GMC-I Messtechnik GmbH 81
Accessories
11.4 Interface Accessories (not included)
USB X-TRA Bidirectional Interface Adapter
This adapter makes it possible to connect the
METRACAL MC to a USB port at a PC. The adapter allows for data
transmission between the multimeter and the PC.
METRAwin 10 PC Analysis Software
METRAwin 10 PC software is a multilingual, measurement data log-
ging program for recording, visualizing, evaluating and
documenting measured values from METRAHIT multimeters.
The following conditions must be fulfilled in order to allow for use
of METRAwin 10:
Hardware, Software and Driver
• IBM compatible Windows PC, 200 MHz Pentium processor or
faster with at least 64 MB RAM
• SVGA monitor with at least 1024 x 768 pixels
• Hard disk with at least 40 MB available memory capacity
•CD ROM drive
• Microsoft compatible mouse
• Windows supported printer
• One USB port for use of the USB X-TRA
– with installed driver USB2COM (virtual COM interface) for
Windows 2000, XP and VISTA
or
– with Driver Control for Windows XP, VISTA and 7.
METRAwin

90-2 Calibration Software (in preparation)
This software allows for paperless documentation and
management of calibration results, as well as remote control of
the calibrator.
The calibrator’s sequence controls can be implemented online, or
offline after downloading complete calibration sequences.
The following conditions must be fulfilled in order to allow for use
of METRAwin

90-2:
Hardware:
• IBM compatible Windows PC, 200 MHz Pentium processor or
faster with at least 64 MB RAM
• SVGA monitor with at least 1024 x 768 pixels
• Hard disk with at least 40 MB available memory capacity
• CD ROM drive
• Microsoft compatible mouse
• Windows supported printer
• 1 USB port for the use of the USB X-TRA
Software:
• MS Windows 95, 98, ME, NT 4.0, 2000 or XP