Operation Manual

50 GMC-I Messtechnik GmbH
Device and Measuring Parameters
dAtE – enter date
Entering the current date makes it possible to acquire measured
values in real-time.
1nFo
 ...  SET rAtE  ...  dAtE
31.12 (DD: day . MM: month)
 
2005 (YYYY: year)
 
Date and time must be reentered after replacing the batteries.
tiME – set time
Entering the correct time makes it possible to acquire measured
values in real-time.
1nFo  ...  SET rAtE  ...  t iME
10:24 (hh:mm)  
Date and time must be reentered after replacing the batteries.
CLIP – set transformation factor (METRAHIT⏐BASE only)
See chapter 5.7.3 ff.
6.5 Default Settings
Previously entered changes can be undone, and the default
settings can be reactivated. This may be advisable under the
following circumstances:
• After the occurrence of software or hardware errors
• If you are under the impression that the multimeter does not
work correctly
Ð Disconnect the device from the measuring circuit.
Ð Remove the batteries temporarily (see also chapter 9.2).
Ð Simultaneously press and hold
the and keys,
and reinsert the batteries at the same time.
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
ZERO
ESC
ON / OFF
LIGHT