Operation Manual

GMC-I Messtechnik GmbH 53
Interface Operation
7.2 Configuring Interface Parameters
irStb – status of the infrared receiver in the stand-by mode
There are two possible switching statuses for the infrared
interface when the multimeter is switched off:
ir on: IR appears at the display and the infrared interface is
active, i.e. signals such as making commands can be
received, and power is consumed even though the
multimeter is switched off.
ir oFF: IR does not appear at the display and the infrared
interface is switched off, signals cannot be received.
1nFo
 ...  SET rAtE  ...  irStb
ir on / ir oFF 
(irstb = ir oFF = default setting)
Addr – Address
If several multimeters are connected to the PC via an interface
adapter, a separate address can be assigned to each instrument.
Address number 1 should be selected for the first instrument, 2
should be assigned to the second and so forth.
1nFo
 ...  SET rAtE  ...  Addr
00 ... 01 ... 15

(15 = default setting)
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER