User manual

GMC-I Gossen-Metrawatt GmbH 49
Device and Measuring Parameters
6.1 Paths to the Various Parameters 6.2 List of All Parameters
bAtt :
uers ion :
1temp
dAtE
:
t iME :
0CCvP :
1nFo
tEMPSEnd SET StorE
StArt
StoP
000.0
CLEAr
StArt
StoP
Sub-Menus / Parameters ↓
rAtE
resol *
0..d iSP
vpm *
CL iP
APoFF
v_1so
bEEP
irStb
Addr
dAtE
t iME
°C
°F
Main Menus →
Query Set Set Set Set
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
01nfo
MEASURE
SETUP
020 . 00
V
DC
AC
TRMS
Selection
FUNC
ENTER
Selection
FUNC
ENTER
Selection
FUNC
ENTER
Selection
FUNC
ENTER
* Function only available with customer-specific variant
Parameter Page: Header
0.d iSP 51: 0.diSP – show/hide leading zeros
Addr
55: Configuring Interface Parameters
APoFF
52: APoFF – specified time for automatic shutdown and continuous ON
bAtt
50: bAtt – query battery voltage
bEEP
52: bEEP – set limit value for continuity testing
CLEAr
23: Measurement Data Recording
CL IP
45: Direct and Pulsating Current Measurement with Clip-On Current Sensor
A DC and A (DC+AC)
46: Alternating Current Measurement with Clip-On Current Sensor, A AC and Hz
dAtE
50: dAtE – query date, 53: dAtE – enter date
EMpty
23: Measurement Data Recording
1nfo
50: Querying Parameters – InFo Menu (as moving letters)
irStb
55: Configuring Interface Parameters
itemp
50: ItEMP – query reference temperature
0CCvP
23: Measurement Data Recording
rAtE
51: rAtE – set the sampling rate
resol
51: rESoL – high resolution for V DC and W (customer-specific function)
SEnd
54: Activating the Interface
SET
51: Entering Parameters – SETUP Menu
StArt
23: Measurement Data Recording
StoP
store
tEMP
33: Temperature Measurement: Temp RTD and Temp TC
t iME
50: tiME – query time, 53: tiME – set time
v1so
52: U_ISo – select test voltage
vpm
52: RPM – revolutions per minute (customer-specific function)
uErS ion
50: vErSion – query firmware version