Operation Manual

24 GMC-I Messtechnik GmbH
Control Functions
During Recording
STORE is displayed underneath the analog display during memory
mode operation, and memory occupancy can be controlled:
StoP
 000.3%
The following message appears as soon as memory is full: “ 100 . 0 %”.
In order to be able to observe measured values during recording,
switch to the measuring function by pressing MEASURE | SETUP.
The display is returned to the memory menu after once again
pressing MEASURE | SETUP.
A new memory block is created when another measuring function
is selected with the rotary switch or the FUNC | ENTER key. Data
storage then continues automatically.
Ending Recording
Ð “StoP ” appears at the display after pressing MEASURE | SETUP.
StoP start
Ð Acknowledge the “StoP ” display by pressing FUNC | ENTER.
STORE is cleared from the display, indicating that recording has
been ended.
Ð Press MEASURE | SETUP in order to return to the measuring
function.
Ð Memory mode operation can also be exited by switching the
multimeter off.
Querying Memory Occupancy
Memory occupancy can be queried during recording with the
help of the “1nFo ” menu (see also chapter 6.3).
Memory occupancy range: 000.1% to 099.9%.
1nFo bAtt :  ...  0CCvP %: 017.4 %
Memory occupancy can be queried before recording is started via
the “StorE” menu.
1nFo
 ...  StorE 017.4 %  StArt
Clear Memory
This function deletes all measured values from memory!
This function cannot be executed during memory mode
operation.
1nFo
 ...  StorE 017.4% w StArt
 CLEAr empty
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER