Operation Manual

SECULIFE ESPRO
CUSTOM LOAD SETS. To simplify the selection of commonly used load configurations, 10 custom
resistor sets are available. Each resistor set can consist of any combination of the available calibrated
loads. The number of loads and load calibration is performed in the Factory Setup Screen.
A custom load set can be configured in the Setup Screen by either using to highlight the line
and to toggle the available custom set resistance,
or by using the key to access the Custom Resistor Set Menu.
This menu shows the current values of the loads as set in the Factory Setup Screen. The value of a Load
Set can be changed by using to highlight the load line and to include or remove the resistor
from the custom set. The total series resistance of the selected resistors is shown to aid in customizing
the custom resistor set.
NOTE: If individual selected load values are changed in the Factory Setup Screen, the resistance value
of the sets will change accordingly.
The Setup Screen can be exited using the key.
GMC-I Messtechnik GmbH 23