Operation Manual

SECULIFE ESPRO
24 GMC-I Messtechnik GmbH
LOAD TABLE – Up to twelve Load Resistance Values (each with a range from 0.0 to 6,500.0
ohms) may be set in the FACTORY SETUP Configuration. These values are used in
combination with the Custom Load Sets to determine the Load Configuration Table. These
options are available if the Load Selection parameter is set to “Table”. The settings will be the
individual calibrated loads followed by the Load Sets. Since these values can be set to the
actual values of the real resistors, this allows for maximum accuracy in the wattage
calculations. By default, the following values are loaded into this table when the SECULIFE
ESPRO instruments ships from the factory:
Load #1: 10 
Load #2: 20 
Load #3: 30 
Load #4: 50 
Load #5: 100 
Load #6: 200 
Load #7: 300 
Load #8: 500 
Load #9: 1000 
Load #10: 2000 
Load #11: 3000 
Load #12: 4000 