Operation Manual
GMC-I Messtechnik GmbH 31
SECULIFEESXTRA
Leakage Test 1b - I need to measure the leakage current from the dispersive (REM) port to ground.
Solution:
1) Select Measure RF Leakage from the main menu.
2) If the Leakage selection at the top of the screen does not show Leakage 1b, press the button and
select Leakage 1b from the test mode menu.
3) Connect the Dispersive output from the DUT to the Dispersive inputs on the SECULIFE ES
XTRA.
If you are using the cables from the SECULIFE ES
XTRA accessory kit, use the Blue cable without the
clear pin.
4) Connect earth ground port on the SECULIFE ES
XTRA to the ground lug on the back of the DUT. If you
are using the cables from the SECULIFE ES
XTRA accessory kit, use the green cable and green
alligator clip.
NOTE: To see how the SECULIFE ES
XTRA is internally configured, press the Test Setup button. To
close the image, press Test Setup again.