Operation Manual
64 GMC-I Messtechnik GmbH
SECULIFEESXTRA
List Values Tab - This allows the user to configure a list of CQM resistances that are used in the test.
During the test the CQM resistance will be sequentially set to the values shown in the CQM resistance list.
The step can be configured to stop when the CQM state is either alarm or normal.
The Set Tolerance button is used to determine the pass / fail parameters. The CQM resistance will be
stepped until the CQM state is either normal or alarm as programmed in the step. This point is called the
trip resistance. The tolerance configuration allows the user to configure the trip points that result in a pass
or fail status for the test.