Operation Manual
66 GMC-I Messtechnik GmbH
SECULIFEESXTRA
RF Energy / Leakage steps - These steps will begin by showing the operator the step title and
instructions. After the instructions are read, pressing the Show Meter button will allow the operator to
perform the measurement. If the step is setup for the operator to trigger the DUT, the operator must
activate the DUT and then press Capture to analyze the measurement and validate the step. If the step is
setup to automatically trigger the generator, the operator simply presses the Capture button and the DUT
will automatically be activated and the measurement analyzed.
The step can be re-run by pressing the New Capture button after a reading has been taken.