Operation Manual

80 GMC-I Messtechnik GmbH
SECULIFEESXTRA
When SECULIFE ESXTRA is selected as the trigger source, the activation can be setup manually or by
DUT manufacturer and model. For Manual Setup, the user selects the desired footswitch output to be
used. If RS-232 is enabled, the user also selects the baud rate and enters commands to be used for DUT
setup and control. When entering commands use "%P" to represent the power level. In the example
below, SECULIFE ES
XTRA would send the command ":FTP300" when setting the power level to
300 watts.
When the DUT Setup is set to Setup by Model, the user selects the DUT manufacturer and model as well
as the desired output mode. The SECULIFE ES
XTRA handles all of the RS-232 and footswitch output
setup.