Datasheet

ManualsBrandsGOSSEN METRAWATT ManualsLaboratory & Bench PSUsBench PSU (adjustable voltage) 0 - 80 Vdc 0

SLP KONSTANTER Series SLP 120 / 240 / 320

Laboratory Power Supplies

3-348-796-03

7/5.15

GMC-I Messtechnik GmbH

Application

The SLP-KONSTANTER series (Single Output Laboratory Power

Supplies) includes single-channel laboratory power supplies for

universal use in research and development, production, training

and service.

The instruments are capable of maintaining either constant volt-

age or constant current levels, and are deliver 120 W, 240 W or

320 W of nominal power over a wide range thanks to the auto-

ranging output.

Setpoint Configuration

Precision manual adjustment of voltage and current is accom-

plished with ten-turn potentiometers whose setting ranges Ulim

and Ilim can be limited with the help of a screwdriver, in order to

prevent inadvertent adjustment to undesirably high values.

Display

Two large, 3½ place digital LED displays indicate the measured

output voltage and output current. Furthermore, they can be

switched to setpoint display as well, which is especially advanta-

geous for current adjustment.

Control mode displays in the characteristic curve field indicate

respective operating conditions.

Outputs

Floating outputs are available at both front and rear panels.

Activation or deactivation is accomplished by pressing a key, or

with a signal to the integrated analog interface which is included

as standard equipment.

As soon as sensor cables are connected to the terminals, the

KONSTANTER is automatically switched to remote sensing.

Housing

The quiet, temperature controlled fan prevents unnecessarily high

noise levels in working areas.

The rugged metal housing is closed at both top and bottom, and

is equipped with mounting feet and a tilt stand at the rear.

Several units can be quickly and easily fastened to one another

for the creation of multi-channel units, or can be installed to a 19"

rack with the appropriate mounting sets.

Only one electrical outlet is required for the supply of mains power

to multi-channel units.

• Very short response times thanks to BET technology

(bidirectional energy transformation)

• Auto-ranging output with 120 W, 240 W or 320 W

• Output power is doubled in short-time operating range

• Remote sensing

• Minimum residual ripple

• Very good dynamic control parameters

• Output ON / OFF function

• Output terminals at front and rear panels

• Master-slave operation for parallel and series connection

• Protection against excessive temperature

• Minimal power loss

• Compact design and minimum weight

Summary of content (8 pages)

PAGE 1
SLP KONSTANTER Series SLP 120 / 240 / 320 Laboratory Power Supplies • Very short response times thanks to BET technology (bidirectional energy transformation) • Auto-ranging output with 120 W, 240 W or 320 W • Output power is doubled in short-time operating range • Remote sensing • Minimum residual ripple • Very good dynamic control parameters • Output ON / OFF function • Output terminals at front and rear panels • Master-slave operation for parallel and series connection • Protection ag
PAGE 2
SLP KONSTANTER Series SLP 120 / 240 / 320 Laboratory Power Supplies Output Working Range U/V Unom. Applicable Regulations and Standards Pnom. Short-Time Operating Range 0.5 Voltage Setting Range Current Setting Range Unom. 0 0.5 Inom. Inom.
PAGE 3
SLP KONSTANTER Series SLP 120 / 240 / 320 Laboratory Power Supplies Dimensional Drawing (benchtop instrument) Power Supply Outlet for Use with Multiple Units 221.5 KONS TANTER SLP 240-40 40V 40V/6A CV Volt Amp 240W 20V/12A CC +SENSE - + OUTPUT 230V 50-60Hz FUSE T4/250V 14 ANALOG INTERFACE -SENSE - Ilim Iset AGND Uset + Uset +Iset U-MON I-MON Uset DISPLAY Uset/Iset SIG1 OUT SIG2 OUT ON OFF -TRG IN 88 Ulim OUTPUT + TRG IN + 15V 12A POWER Mains Power Input 397.5 380.
PAGE 4
SLP KONSTANTER Series SLP 120 / 240 / 320 Laboratory Power Supplies Characteristic Values, 120 W Series Unless otherwise indicated, all entries represent maximum values and are valid within an operating temperature range of 0 to 50° C, the nominal power range and a line voltage range of 230 V ± 10% after a warm-up period of 30 minutes. Description (abbreviated designation) SLP 120-20 SLP 120-40 SLP 120-80 Type 32 N 20 R 10 32 N 40 R 6 32 N 80 R 3 Voltage Setting Range 0 ... 20 V 0 ... 40 V 0 ...
PAGE 5
SLP KONSTANTER Series SLP 120 / 240 / 320 Laboratory Power Supplies Characteristic Values, 240 W Series Unless otherwise indicated, all entries represent maximum values and are valid within an operating temperature range of 0 to 50° C, the nominal power range and a line voltage range of 230 V ± 10% after a warm-up period of 30 minutes. Description (abbreviated designation) SLP 240-20 SLP 240-40 SLP 240-80 Type 32 N 20 R 20 32 N 40 R 12 32 N 80 R 6 0 ...
PAGE 6
SLP KONSTANTER Series SLP 120 / 240 / 320 Laboratory Power Supplies Characteristic Values, 320 W Series Unless otherwise indicated, all entries represent maximum values and are valid within an operating temperature range of 0 to 50° C, the nominal power range and a line voltage range of 230 V ± 10% after a warm-up period of 30 minutes. Description (abbreviated designation) SLP 320-32 Type 32 N 32 R 18 Nominal Output Data Voltage Setting Range 0 ... 32 V Current Setting Range 0 ...
PAGE 7
SLP KONSTANTER Series SLP 120 / 240 / 320 Laboratory Power Supplies Ambient Conditions Vibration Resistance Impact Resistance Temperature Range Humidity Cooling IEC 68-2-6: 1990 10 ... 55 Hz, 0.3 mm, 1 oct. / min. 3 x 30 min. IEC 68-2-27: 1989 15 gr., 11 ms, semi-sinusoidal, 3 x 6 impacts operation: 0 ... 50° C at > 40° C current derating storage: –25 ...
PAGE 8
SLP KONSTANTER Series SLP 120 / 240 / 320 Laboratory Power Supplies Scope of delivery • SLP KONSTANTER 32 N • Mains power cable with earthing contact plug • Operating instructions (printed) Accessories Description Comment Article No. 19" Adapter, 1 x 32 N Required for mounting 1 type 32 N ... instrument to a 19" rack K990A 19" Adapter, 2 x 32 N Required for mounting 2 type 32 N ... instruments to a 19" rack K990B Mains Jumper Cable, 0.