User Guide

All Rights reserved, No Spreading abroad without GOSUNCN Permission 68
ME3630
Hardware Development Guide
WARNING:
The product’s transportation, storage and processing must conform to IPC/JEDEC J-STD-033.
7.4.2. BAKING DEVICE AND OPERATION PROCEDURE
Baking device: Any oven where the temperature can rise up to 125°C or above.
Precautions regarding baking: during the baking process, the modules should be put in the high-temperature resistant pallet
flatly and slightly to avoid the collisions and frictions between the modules. During the baking process, do not overlay the modules
directly because it might cause damage to the module’s chipset.
7.4.3. MODULE BAKING CONDITIONS
See the baking parameters in Table 7-1.
8. OEM/INTEGRATORS INSTALLATION MANUAL
Important Notice to OEM integrators
1. This module is limited to OEM installation ONLY.
2. This module is limited to installation in mobile or fixed applications, according to Part 2.1091(b).
3. The separate approval is required for all other operating configurations, including portable configurations
with respect to Part 2.1093 and different antenna configurations
4. For FCC Part 15.31 (h) and (k): The host manufacturer is responsible for additional testing to verify
compliance as a composite system. When testing the host device for compliance with Part
15 Subpart B, the host manufacturer is required to show compliance with Part 15 Subpart B while the
transmitter module(s) are installed and operating. The modules should be transmitting and the evaluation
should confirm that the module's intentional emissions are compliant (i.e. fundamental and out of band
emissions). The host manufacturer must verify that there are no additional unintentional emissions other than
what is permitted in Part 15 Subpart B or emissions are complaint with the transmitter(s) rule(s).
The Grantee will provide guidance to the host manufacturer for Part 15 B requirements if needed.
End Product Labeling
When the module is installed in the host device, the FCC ID label must be visible through a window on the final
device or it must be visible when an access panel, door or cover is easily re-moved. If not, a second label must
be placed on the outside of the final device that contains the following text: “Contains FCC ID:
2APNR-ME3630”
The FCC ID ID can be used only when all FCC compliance requirements are met.