User's Manual

1.
Choose an area to set up in car.
3
4
This product is a smart wireless charger with simple
and decent design, which is compatible with smart
phone or device for QI standard. It also can support
fast charging of iPhone or Samsung.
It is convenient and fast. You can
enjoy a free charging experience
LED
Non- skid rubber
Pedestal is detachable.
It can stick on platform
or clamp on AC vent.
Blade clip
3M double-sided adhesive
Damped visors allow
the wireless charger
to rotate to any Angle
Tear off the protective film of
3M on the bottom surface an d
stick to the selected pos ition
(clean and keep dry before to
uching) Press for a few sec onds
to make it firm and sticky.
Normal charge: slow flash
Fast cha rg e: l ong bright
FOD: f ast flash
Place the device with wireless
charging receiving device on
the charger, as shown in the
picture
Th e X p o s i t i on f i l m i s
cl a m p e d b e tw e e n t h e
mo b i l e p h o ne w i t h w i r e le s s
ch a r g i n g f un c t i o n a n d th e
pr o t e c t i on s l e e v e , w hi c h
ca n a c c u r a te l y a n d a u t om a t i c a l ly
lo c a t e c h a rg i n g
When the product is used in the car, the phone's
safety protection mec hanism may be activated
due to the sun exposure at high temperature, so
the phone cannot be charged immediately. After
the temperature is lowe red in the car room, the
product can return to nor mal use
The fast charge mode requ ires QC 2.0 adapter.
For charging efficiency, the thickness
of phone's case is suggested less than 2mm,
and over 6mm may lead to slow charging
or failure of charging
X1
X1
X1
X1
5.
Introduction
Appearance and Overview
Charging area
Pedestal
Instruction:
Connect the wireless charging
device to the power supply of
the car via USB cable, and
make it electrified (LE D will
shine, indicating successful
power supply)
Different application
Attention:
Do not use metal case.
Please keep the environment
temperature in 0-45℃
Please keep the charger and receiver away from water and other liquid.
If cleaning the charger, please make sure the power is disconnected.
Parts List
Wireless charger
USB cable
X mark locating card
Manual
Input inte rface: 5V/2A, 9V/1.8A
Out put: 5V /1A , 9V/1 .8A
MicroUSB
input interface
FCC Statement
Changes or modifications not expressly
approved by the party responsible for co
mpliance could void the user's authority t
o operate the equipment.
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no g
uarantee that interference will not occur in a part
icular installation. If this equipment does cause ha
rmful interference to radio or television reception,
which can be determined by turning the equip
ment off and on, the user is encouraged to try
to correct the interference by one or more of
the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equip
ment and receiver.
-- Connect the equipment into an outlet on a ci
rcuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/
TV technician for help
1.
在汽车内部选定安装位置
3
4
本产 品 是 一款 智能 无 线充 电产 品,设计 简 洁大 方,与任 何
QI标 准 手机 及设 备 兼 容,更 提供 苹果 及 三星 快充模式,
方便 快 捷,为您 提供 无 束 缚 的充 电体 验
电源指示灯
止滑垫
X形定位片
底座可分离,可选择沾黏于
平台处或 夹 于 出 风 口叶片上
叶片夹
3M双 面胶
阻尼万象轴
使得 无 线充 电器
可旋 转 至任 意角 度
将底面3M胶保护膜撕下,
沾到选定 位 置(沾 合 前 将
该区域清 洁 并 保 持 干燥)
按压数秒 钟 使 其 稳 固沾黏
一般充电:慢 闪
快速充电:恒 亮
异物检测:快 闪
把带 有无线 充 电 接收装 置 的
设备,放置 在 充 电器上,
如图所 示
将磁力X定位片夹 于 自 带
无线充电 功 能 之 手 机与
保护套之 间,即 可 准 确
自动定位 充 电
&
本产 品 于车内 使 用 时,可 能 因 阳光
高温曝晒 而 启 动 安 全保护机 制,无
法立即为 手 机 充 电,稍 于车室内 温
度降低后,即 可 恢 复 正 常使用
快充模式须使 用Q C 2 . 0适配器
保护 套 厚度2mm以下为 最 佳 充 电效率,
超过6mm可能导 致 充 电 速度慢 或 无 法 充 电
不可使用 金 属 保 护 套
X1
X1
X1
X1
5.
输入:5V/2A ,9 V/ 1. 8A
输出:5V/1A ,9 V/ 1. 2A
MicroUSB输入接口
Car Wirelss Charger
User manual
150克銅版紙,正反印刷,風琴折
Caution: Any changes or modifications to this device not
explicitly approved by manufacturer could void your
authority to operate this equipment.