2018 WP450 Series FCC ID:2AOQ7-WP450V2 Quick Install Guide CellGate Support: 972-231-1999 option 2
AOQ7-WP450V2
2AOQ7-WP450V2
App Credentials and Device Information 1. After full review of the provided Quick Install Guide, power up the Watchman unit. 2. Allow at least 10 minutes after power up for cellular signal to connect. (The device is not embedded in other cell phone devices, but by inserting Ethernet cable into the only network ports on the it that can connect to 3G/4G router, then to Cellgate Mobile Connect app. The protocol is TCP/IP.) 3. ■ On WP450 series, enter the device number into the 4. Wait 60 seconds. 5.
9. Confirm a picture was received. 10. Press “Back” in the top left. 11. Select the Watchman Gate 12. Press the “Open Momentarily” button. The gate should open for the duration set in the timer and the Watchman should audibly confirm “Access Granted”. 12a. If the Watchman does not say “Access Granted” and the gate does not open, please check the unit’s network connection and power. 12b.
15. After login initiate a call from the Watchman unit. WP450 Series During the call you should see live video feed in the Watchman app and hear audio from both the app and the 16. Watchman unit. 17. Press the Open button. You should hear a tone from the Watchman unit and the gate should open. 18. Congratulations! You have successfully activated the Watchman! Please leave the customer a key for their Watchman.
FCC Caution: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions : (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
