User Manual

45. Remove bearing wavewasher (529) from bearing

bore (Fig. Y).

46. Remove drive shaft (122B) with ball bearings

(112) from bearing housing (228) (Fig. Y).

47. Press bearings (112) off shaft and discard.

48. Remove lip seal (333D) as shown and discard

(Fig. Z).

INSPECTIONS

Model 3296 parts must be inspected to the following

criteria before reassembly to ensure pump will run

properly. Any part not meeting required criteria should

be replaced.

NOTE: Various tolerances specified on the 3296

are held extremely close, measure parts at standard

temperature 68°F(20°C) to ensure accurate

measurement.

CASING (100)

Casing (100) should be inspected for excessive wear or

pitting. It should be repaired or replaced if it exceeds

the following criteria.

Table 8

Minimum Casing

Thickness

Group Pump Size

Minimum

Thickness Inches

(mm)

2x3-8

3x4-8

3x4-8G

1x2-10

2x3-10

3x4-10H

x3-13

2x3-13

0.31 (7.9)

0.37 (9.4)

WEAR RING CLEARANCES

Refer to Table 9 to check wear ring clearances.

36 3296 M Group 6/05

Fig. Y

Fig. Z