Owner's manual

Commissioning, Startup, Operation, and Shutdown
If the pump size is... Then...
1. Driver
2. Pump end plate
3. Bearing housing
4. Jam nut
3. Put the pump-half of the coupling guard in place:
a) Slightly spread the bottom apart.
b) Place the coupling guard half over the pump-side end plate.
1. Annular groove
2. Pump-side end plate
3. Driver
4. Pump half of the coupling guard
The annular groove in the coupling guard half must fit around the end plate.
42 3298 Family Installation, Operation, and Maintenance Manual