Instruction Manual

DISASSEMBLY & REASSEMBLY

REQUIRED TOOLS ............................31

PREPARATION FOR DISASSEMBLY .................31

DISASSEMBLY...............................32

INSPECTIONS ...............................34

REASSEMBLY ...............................35

REQUIRED TOOLS

Hoist and Strap

Socket Sizes (mm): 12, 14, 16, 19, 20

Torque Wrench for reassembly

Wrench Sizes (mm): 12, 16, 20

Allen Wrenches (mm): 12, 14, 16, 19, 22

Pry Bars

Induction Bearing Heater

Feeler Gauges

Dial Indicator

Cleaning Agents

PREPARATION FOR DISASSEMBLY

! WARNING

Mixers may handle hazardous and/or toxic fluids.

Skin and eye protection are required. Precautions

must be taken to prevent injury or environmental

contamination.

NOTE: Before disassembling the mixer for overhaul,

ensure all replacement parts are available.

1. Lock out power supply to driver.

2. Shut off all valves controlling flow to and from

mixer.

3. Drain liquid from piping, flush mixer if necessary.

4. Disconnect all auxiliary tubing and piping.

5. Remove coupling guard (Fig. 25).

6. Disconnect coupling (Fig. 25).

7. Either remove mixer coupling hub or move hub

down shaft to bearing frame.

8. If unit is oil lubricated, drain oil from bearing

frame by removing bearing frame drain plug (408B).

Replace plug after oil is drained.

3501 IOM 11/10 31

Fig. 25