Instructions / Assembly
Table Of Contents
- 1 Introduction and Safety
- 2 Handling and Storage
- 3 Technical Description
- 4 Installation
- 5 Use and Operation
- 5.1 Precautions
- 5.2 Before starting
- 5.3 First starting
- 5.4 Air purge
- 5.5 Setting the timer
- 5.6 Operation modes
- 5.6.1 Fix speed models
- 5.6.2 Variable speed models
- 5.6.3 Fix speed models with fix value temperature control
- 5.6.4 Fix speed models with variable value temperature control
- 5.6.5 Autocirc pumps
- 5.6.6 LED light
- 5.6.7 Motor protection from overtemperature
- 5.6.8 Dry run protection
- 5.6.9 Power Down Reset (PDR)
- 5.6.10 Temperature sensor error mode
- 6 Maintenance
- 7 Troubleshooting
- 8 Technical Information
- 9 Disposal
- 10 Warranty
en – Original Instructions
Installation, Operation and Maintenance Manual 23
Permitted positions for recirculating pumps
Figure 8
Autocirc pumps - Installation sequence
1. First read and follow the concerning instructions in section
4.3.1 Guidelines for the
hydraulic system on page 20-21.
2. Fasten the Autocirc unit to the wall under the sink using the wall bracket provided in the
Autocirc kit. Be sure the pump timer is turned toward the front and is accessible for setting
and changing the time. The pump must be installed only in vertical position, as shown in
Figure 9.
Figure 9