Use Instructions

HK Audio
®
• Postfach 1509 • 66595 St. Wendel • Germany • [e-mail] • www.hkaudio.com
International Inquiries: fax [phone] • [e-mail]
Subject to change without notice • Technische Änderungen vorbehalten
Copyrights 2017-2020 Music & Sales GmbH • 07/2020
For USA:
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) This device must accept any interference received, including
interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for
an uncontrolled environment. End users must follow the specic operating
instructions for satisfying RF exposure compliance. This transmitter meets
both portable and mobile limits as demonstrated in the RF Exposure Analysis.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter except in accordance with FCC multi-transmitter
product procedures.
For Canada:
Under Industry Canada regulations, this radio transmitter may only operate
using an antenna of a type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential radio interference to
other users, the antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (e.i.r.p.) is not more than that
necessary for successful communication.
CAUTION: Risk of explosion if the battery is replaced by an incorrect type.
Warning: Disposal of a battery into re or a hot oven, or mechanically
crushing or cutting of a battery, that can result in an explosion. Leaving a
battery in an extremely high temperature surrounding environment that can
result in an explosion or the leakage of ammable liquid or gas. A battery
subjected to extremely low air pressure that may result in an explosion or the
leakage of ammable liquid or gas.
The MAX operate temperature: 45°C.
THis device contains licence-excempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may
cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est
conforme aux CNR d’Innovation, Sciences et Développement économique
Canada applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes :
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment o
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Changes or modications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
The equipment complies with FCC/IC RSS-102 radiation exposure limits set
forth for an uncontrolled environment. The equipment should be installed and
operated with minimum distance 20cm between the radiator & your body.