Product Manual A

ManualsBrandsGPI ManualsAC Powered Fuel Pumps115V Fuel Transfer Pump — 30 GPM, Meter

M-3130 &

M-3130-RDP Series

115/230 Volt Super Duty Fuel Pumps

M-3130-ML Manual Nozzle M-3130-AL Automatic Nozzle

M-3130-PO Pump Only

Owner’s Manual

Rev. F 921929-03

09/12

To the owner...

Congratulations on receiving your GPI Super Duty Fuel Pump.

We are pleased to provide you with a system designed to give

you maximum reliability and efciency.

Your fuel pump is designed, tested, and approved for use with

gasoline, kerosene, and diesel fuel. Please take all due pre-

cautions when handling these ammable liquids. Your safety

is important to us.

Also, to assure the longest possible service life, it is important

that you follow the operation and maintenance procedures

outlined in this manual. We are proud to provide you with a

quality product and dedicated support. Together with your

conscientious use, we are sure that you will obtain years of

safe, dependable service.

President

Great Plains Industries, Inc.

5252 East 36th Street North

Wichita, KS USA 67220-3205

TEL: 316-686-7361

FAX: 316-686-6746



SAVE THESE INSTRUCTIONS

STOP

DO NOT RETURN

THIS PRODUCT

TO THE STORE!

Please contact GPI before returning

any product. If you are missing

parts or experience problems with

your installation, our Customer

Support Department will be happy

to assist you.

GPI Customer Support

800-835-0113 or

316-686-7361

TABLE OF CONTENTS

General Information ..........................................................2

Safety Instructions ............................................................2

Installation ........................................................................2

Operation ..........................................................................4

Troubleshooting ................................................................5

Illustrated Parts List .......................................................... 6

Specications ...................................................................7

Parts and Service .............................................................7

Great Plains Industries, Inc. is a member of

the Petroleum Equipment Institute.

Summary of content (8 pages)

PAGE 1
5252 East 36th Street North Wichita, KS USA 67220-3205 TEL: 316-686-7361 FAX: 316-686-6746 SAVE THESE INSTRUCTIONS M-3130 & M-3130-RDP Series 115/230 Volt Super Duty Fuel Pumps M-3130-ML Manual Nozzle M-3130-PO Pump Only M-3130-AL Automatic Nozzle Owner’s Manual STOP DO NOT RETURN THIS PRODUCT TO THE STORE! Please contact GPI before returning any product.
PAGE 2
GENERAL INFORMATION There are inherent dangers wherever flammable fuel and AC electrical sources are in close proximity. Your pump is designed for use only with thin viscosity petroleum fuels such as gasoline (up to 15% alcohol blends such as E15), diesel fuel (up to 20% biodiesel blends such as B20) and kerosene. Do not use this pump for dispensing any fluids other than those for which it was designed. Using the pump with other fuels can damage components and void the warranty.
PAGE 3
Install Nozzle Hanger (Not applicable to pumps with -RDP suffix) Attention: The nozzle hanger for your pump was removed before shipping to protect against damage. To reinstall the nozzle hanger follow the steps below. 1. Remove the two 1/4"-20 x 1/2" bolts and the two flat washers from the switch coverplate. 2. Place the two bolts through the nozzle cover and then place the two flat washers on the bolts. The washers are used as spacers to set the nozzle hanger away from the switch coverplate. 3.
PAGE 4
OPERATION DANGER To prevent physical injury, observe precautions against fire or explosion when dispensing fuel. Do not operate the system in the presence of any source of ignition including running or hot engines, lighted cigarettes, or gas or electric heaters. WARNING Observe precautions against electrical shock when operating the system. Serious or fatal shock can result from operating electrical equipment in damp or wet locations. CAUTION Avoid prolonged skin contact with petroleum fuels.
PAGE 5
TROUBLESHOOTING SYMPTOM PROBABLE CAUSE A. MOTOR DOES NOT RUN 1. No electrical power to pump 2. Auxiliary temperature-limiting device tripped Allow motor to cool. Auxiliary temperature-limiting device will automatically reset. 3. Rotor or vanes jammed Remove coverplate and check for damage or obstruction. B. MOTOR RUNS, BUT 1. Tank level low Add fuel to tank. 2. Clogged filter assembly Remove and clean filter assembly. 3.
PAGE 6
ILLUSTRATED PARTS LIST 14 13 M-3130-RDP ONLY 12 33 11 15 10 9 8 3 1 5 16 2 30 7 6 29 22 17 28 4 32 26 31 18 25 21 23 27 24 20 19 Item No. Part No. Description 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 904006-38 133032-02 901003-15 121010-11 133041-1 904006-33 133027-1 906006-53 904006-54 133039-03 133026-1 133521-01 13312401 13312301 904006-57 133042-1 904006-49 No. Req’d. Hex Head Screw 3/8 - 16 x 1.......... 2 Coverplate.......................................
PAGE 7
SPECIFICATIONS PARTS AND SERVICE The M-3130 fuel pump is designed to safely transfer low viscosity petroleum fuels such as gasoline (up to 15% alcohol blends such as E15), diesel fuel (up to 20% biodiesel blends such as B20) and kerosene. The pump is designed for permanent mounting on vented storage tanks, either in-ground or above-ground. RAINPROOF for outdoor use. In order to preserve the UL Listing for pump safety, return the entire pump to the factory for repair or replacement.
PAGE 8
Limited Warranty Policy Great Plains Industries, Inc. 5252 E. 36 Street North, Wichita, KS USA 67220-3205, hereby provides a limited warranty against defects in material and workmanship on all products manufactured by Great Plains Industries, Inc. This product includes a 2 year warranty from date of purchase as evidenced by the original sales receipt. A 30 month warranty from product date of manufacture will apply in cases where the original sales receipt is not available.