UPPERTONE QUICK ASSEMBLY MANUAL GPK Inc. 535 Floyd Smith Dr.
Quick Assembly Instructions: We fully assemble and test the UPPERTONE, then minimally disassemble it before shipping it you. We describe the re-assembly process below. Part numbers are noted in parenthesis. A complete list of the parts used in the following steps is included at the end of this manual. Figure 1 shows the UPPERTONE when it is fully assembled. Use this figure as well as the photograph on the cover to guide you in the assembly process. Figure 1 A. Frame Assembly (Figures 2 & 3) 1. 2. 3.
B. 1. 2. 3. 4. 5. 6. 7. 8. Crankshaft Assembly (Figures 4 & 5) Slide the Deltoid/Lat Slider (6) down the Frame Post (3) (Figure 4). The pulleys should face the inside of the machine. Remove the Shaft Frame Post (3) Collar (25) and Washer Deltoid/Lat (24) from the Slider (6) Crankshaft (22). Insert the Crankshaft (22) through the square tab on the Frame Post Delt/lat (3) replacing the Slider (6) Washer (24) and Shaft Shaft Collar (25), in that Collar (25) order (Figure 5).
D. Rowing Lever Assembly (Figure 7) 1. 2. 3. 4. 5. Cut the plastic zip ties on the Frame Legs (2) where the Rowing Levers (5) are to be inserted. Insert the Rowing Levers into the Bearings (65). Secure them with Shaft Collars (32) by sliding each Shaft Collar over the protruding Rowing Lever shaft and tightening the black set screw with the Allen wrench. Both Rowing Levers (5) should rest against the Row Stops. Insert the Rowing Adjusters (7) into the Rowing Levers (5).
the regular nut so that it is inside the Frame Post. Slide the Hook Bolt through the second hole in the Frame Post, then thread and tighten the Lock Nut. 2. Hook the center of the cable on the Hook Bolt. Be sure the round sticker marked “front” is facing you. 3. Adjust the swing plates so that the inner one is horizontal and the outer one is vertical on both sides of the central post.
QUICK ASSEMBLY MANUAL PARTS LIST Part No. Description Qty 1. 2. 3. 4. 5. Main Frame Frame Base Frame Post Weight Track Rowing Lever 1 2 1 2 2 6. 7. 12. 14w. 16. Deltoid/Lat Slider Rowing Adjuster Wing Handle Pulley 3" wide bore Pulley 4 ½" - 3/8" bore 1 2 2 2* 2* 22. 24. 25. 26. 27. Crankshaft Washer 5/8" (Nylon) Shaft Collar 13/16" Swing Plate Deltoid/Lat Arm 1 1 1 4 2 28. 29. 30. 30.b. 33.
