Operation Manual

1110
When You’re Done Flying
After landing, pull the Left Control Stick (throttle) fully rearward to power down and wait
for the rotors to stop spinning. Power OFF the remote (press and hold power button)
BEFORE powering OFF the craft. This will ensure that no signals are accidentally sent by
the remote, reducing the chance of injury. After this is done, it is safe to pick up the craft and
disconnect the battery.
Trim Adjustment
Setting Trim & Countering Drift
Even after the craft is calibrated, it may show a tendency to drift while airborne. Adjusting
the trim will help counter this effect and allow for better control the craft.
• To avoid potential damage, adjust the trim while attempting a stable hover.
• Try to avoid making any exaggerated movements with the flight controls.
• Adjust one trim setting at a time to avoid confusion.
Adjusting the trim will help with drift but it will not entirely eliminate it. Turbulence and
other factors may still influence the craft’s flight characteristics.
Craft yaws/spins in place. Adjust Yaw Trim.
Craft banks/rolls left or right. Adjust Roll Trim.
Flying
Use the Right Control Stick to control the
Pitch (forward/backward) and Roll (left/
right) movement of the craft.
Use the Left Control Stick to take off
and control the throttle and Yaw (spin)
movement of the craft.