Operation Manual

11
Flying
Craft/Remote Link
Before flying, the craft and the remote must be linked together and the gyroscopes on the
craft must be allowed to calibrate.
Begin with the craft and remote powered OFF.
Step 1
Connect the battery and close the battery
compartment, then power ON the craft.
The LED navigation lights will blink as the
craft searches for a signal from the remote.
Step 2
Place the craft on a flat, level surface. This
is necessary for the craft’s gyroscopes to
properly align.
Step 3
Power ON the remote. The light on the
remote will blink as it searches for the
signal from the craft. An audible chime will
sound when the remote and the craft have
linked with each other.