USER’S GUIDE V:1246-1019-09 IHH810B 2.
WARNINGS AND PRECAUTIONS • • • • • • • • • • • CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. WARNING: To prevent fire or shock hazards, do not expose this unit to rain or moisture. CAUTION: Use of controls or adjustments or performance of procedures other than those specified may result in hazardous radiation exposure.
FCC Warnings NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
2.1 CHANNEL HOME THEATER SYSTEM WITH DOCK FOR IPOD Features • Docking Station for iPod® • Backlit LCD Display with Digital Clock • Certified iPod Connector installed for iPod docking. • Video Out Jack for iPod photo & video versions, RCA type • Recharge Circuit for iPod/mini/nano/photo/vdeo • Line-In jack for other Audio Players, 3.5mm • Controls connected iPod players • Aux-In Audio Input Jacks, L & R RCA-type • iPod Authentication IC installed • Subwoofer Output Jack, RCA-type • 2.
TABLE OF CONTENTS 6 INTRODUCTION CUSTOMER HELPLINE | 1-314-621-2881 SETUP 10 TELEVISION SETUP 12 IPOD 14 DVD/CD 16 SETUP MENU 17 RADIO 18 COMPANY INFORMATION 20 GPX | HT219B 5
INTRODUCTION PLAY/PAUSE EJECT AUTO PROG.
COMPOSITE VIDEO OUTPUT HDMI OUTPUT COMPONENT OUTPUT S-VIDEO OUTPUT COAXIAL DIGITAL OUTPUT AM & FM ANTENNAS VIDEO POWER INPUT Y Pb Pr AM ANT FM ANT 120V ~ 60Hz COAXIAL S-VIDEO DIGITAL OUTPUT SUBWOOFER L VIDEO OUT SPEAKERS L HDMI OUTPUT R SUB 2.1 CH AUDIO OUT R L R AUX IN SUBWOOFER OUTPUT LEFT SPEAKER OUTPUT RIGHT SPEAKER OUTPUT CUSTOMER HELPLINE | 1-314-621-2881 2.
INTRODUCTION NUMBER KEYPAD EJECT EJECT CHAPTER Press to cycle through chapters on a docked iPod. ALBUM Press to cycle through albums on a docked iPod. SOURCE Press to adjust the current mode (DVD/CD, Radio, iPod, and Aux In). AM/FM Press to switch between AM and FM radio modes. 1 2 3 MUTE 4 5 6 7 8 9 AUTO SCAN ST/MO MEMORY 0 ALBUM SOURCE CHAPTER PLAYLIST AM/FM MENU SETUP TUNING EQ POWER PLAYLIST Press to cycle through playlists on a docked iPod.
EJECT 1 2 3 4 5 6 7 8 9 MUTE AUTO SCAN ST/MO MEMORY CHAPTER PLAYLIST TUNING AM/FM MENU 0 ALBUM SOURCE SETUP EQ POWER PLAY / PAUSE / STOP SLOW Press to view the current DVD in slow motion. PROG Press to program a loaded CD or DVD. TITLE Press to access the title menu on a loaded DVD. SUBTITLE Press to adjust the subtitle language for the loaded DVD. REPEAT Press to cycle through repeat modes for a loaded DVD or CD. VIDEO Press to adjust the component (YUV) video mode to off or on.
SETUP Power VIDEO Plug the attached AC cord into a standard AC power outlet to power the home theater system. Y Pb Pr R SUB 120V ~ 60Hz COAXIAL S-VIDEO DIGITAL OUTPUT VIDEO SUBWOOFER L VIDEO OUT SPEAKERS L HDMI OUTPUT R L 2.1 CH AUDIO OUT Y R AUX IN 120V ~ 60Hz Subwoofer and Speakers COAXIAL S-VIDEO DIGITAL OUTPUT VIDEO OUT SUBWOOFER Plug the speaker and subwoofer cables into the corresponding colored SUBWOOFER/SPEAKER CONNECTIONS.
Remote Requires 2 AAA batteries (included) N OPE Setting the Clock 1 Press the POWER button to turn the home theater system off. 2 Press the CLOCK button, on the remote, once for AM and twice for PM. 3 Use the NUMBER KEYPAD to enter in the current time. You must type in all 4 digits of the time. For example, if it is 8:00, you would press 0, 8, 0, 0. 4 Press the SELECT button to set the adjusted time.
TELEVISION SETUP Composite Video Setup (Good) S-Video Setup (Good) 1 Connect a composite RCA cable to the composite RCA input on a television. 2 Connect the other end of the composite RCA cable to the COMPOSITE VIDEO OUTPUT on the home theater system. 3 Adjust your television to the input setting that matches the connection made in step 1. 1 Connect a s-video cable to the s-video input on a television. 2 Connect the other end of the s-video cable to the S-VIDEO OUTPUT on the home theater system.
VIDEO Y Pb Pr AM ANT FM ANT 120V ~ 60Hz COAXIAL S-VIDEO DIGITAL OUTPUT VIDEO OUT SUBWOOFER L SPEAKERS L HDMI OUTPUT R SUB 2.1 CH AUDIO OUT R L R AUX IN Auxiliary Audio Setup (Good) 1 Connect a stereo RCA cable to the stereo RCA outputs on a television. 2 Connect the other end of the stereo RCA cable to the AUXILIARY INPUTS on the home theater system.
IPOD Docking an iPod 1 Locate the numbered bracket that fits the iPod that will be docked. Each included Bracket has a number on it, indicating which iPod model that bracket is compatible with. See the separate bracket chart page to identify which bracket is needed. 2 Snap the bracket into place over the iPod connector in the Dock for iPod. All Brackets will only fit one way onto the Dock. 3 Connect the iPod to the iPod connector inside the Dock for iPod.
Video Output from an iPod 1 Connect the home theater system to a television using the Composite or S-Video Setup listed on page 12. Please note, video from a docked iPod cannot be output to a television using the component or HDMI video setup. 2 On your iPod, navigate to VIDEOS > VIDEO SETTINGS and turn TV OUT to “ON”. 3 Follow the instructions for Docking an iPod on page 14. 4 Dock the iPod onto the home theater system, and begin playing a video from the docked iPod.
DVD & CD Playing a DVD or CD 1 Press the POWER button to turn the home theater system on. 2 Press the SOURCE button to select DVD mode. 3 Press the EJECT button to open the DISC DRAWER. 4 Load a DVD or CD into the drawer, label side facing up, and press the EJECT button to close the DISC DRAWER. 5 The loaded DVD or CD will start playing automatically. Programming a DVD or CD 1 Begin playing a loaded DVD or CD. 2 Press the PROG button on the remote.
SETUP MENU Entering the Setup Menu Preference Page To enter the setup menu, you must be in DVD mode. 1 Press the SOURCE button to switch to DVD mode. 2 Press the SETUP button to enter the setup menu. To access the preference page, the home theater system must be in full stop mode or the disc drawer must be empty. Press the STOP button twice to enter full stop mode. • TV Type HDMI Setup needs to be set to Off mode in order to adjust the TV Type.
RADIO Playing the AM/FM Radio 1 Press the POWER button to turn the home theater system on. 2 Press the SOURCE button to select radio mode. 3 Press the AM/FM button to switch between AM and FM radio mode. 4 Press the TUNING buttons to adjust the AM or FM radio station. Saving an AM/FM Radio Station 1 Follow the steps for Playing the AM/ FM Radio. 2 When tuned to the desired station, press the MEMORY button on the remote. 3 Press the MEMORY () buttons on the remote to select a preset (ie. P01).
CUSTOMER HELPLINE | 1-314-621-2881 iLive | IHH810B 19
COMPANY INFORMATION International Support To download this User’s Guide in English, Spanish, or French, visit the support section at www.ilive.net. Para transferir esta guía de usuario en inglés, español, o francés, visite la sección de la ayuda en www.ilive.net. Pour télécharger ce guide de l’utilisateur en anglais, espagnol, ou français, visitez la section de soutien chez www.ilive.net. Contact Information Address: 2116 Carr Street, St.
