User's Manual

Cleanup
12 3A0245A
7. Remove drain plug from hopper. Flush with water.
Clean and install drain plug.
NOTE: Cap plug must not be inserted into the female
side of the connector on the Z swivel. Residual pressure
can cause the cap plug to lose the seal. To ensure that
the cap plug properly seals, use cap plug on the inline
gun outlet.
8. Wash all tools.
9. Turn pump control clockwise to start pump.
10. Run pump until clean water flows from applicator.
Continue until hopper is empty.
11. Add additional water and repeat steps 13 - 14,
if necessary.
12. Remove drain plug from hopper. Flush with water.
Clean and install drain plug.
13. Rotate pump control to shut pump off.
ti11804a
ti8794a
ti14878a
ti11670a
ti8793a