User's Manual

Finishing Tools
3A0245A 5
Finishing Tools
Corner Finisher
1. Press pin on top of corner finisher and install onto
valve.
2. Work from bottom to top of vertical angles and from
one end to other on ceiling angles.
3. Use drywall knife to detail corner and ceiling angle
intersections.
Flat Finishing Box
1. Install valve over two screws on box and tighten two
wing nuts.
2. Place flat box at end of joint.
3. Lead with handle and draw the tool along the joint.
4. Near middle of the joint, remove flat box from joint
surface with a sweeping motion.
5. Reverse hand positions and begin again at other
end of joint.
6. Again draw flat box along joint up to previous
stopping point and remove box from joint surface
with a sweeping motion.
7. Use drywall knife to detail seams and overlap.
Automatic Taping Tool
NOTE: Fine flow rate adjustments can be made using
buttons on valve handle.
1. Install trigger assembly and sanitary clamp.
2. Insert pin into trigger assembly.