User's Manual

Operation
8 3A0245A
Startup
Pump Material
1. Mix material in separate bucket. Gradually add
water and mix until desired consistency is achieved.
2. Add mixed material to hopper.
3. Place deflect er into hopper to recirculated material.
NOTE: Keep deflector shield wet once it is in use.
4. Turn sprayer power ON and flip prime valve fully
clockwise to prime pump. Place material hose and
drain line in hopper.
5. After unit is primed, place prime valve in APPLY
FINISH position.
6. Turn flow knob clockwise to increase material flow.
7. Place head of tool over waster bucket and trigger
valve until material flows from tool head. Once all
water has been flushed from hose and tool, position
tool head over hopper until flow rate is determined.
8. Apply a couple of test coats to determine proper
flow speed on sprayer. Fine adjustments can be
made on valve handle to increase or decrease flow
speed.
Fill Tools With Material
Fill Box
1. Remove tool-fill flange.
2. Install box fill adapter.
3. Place slot of box over box fill nozzle.
4. Turn Prime Valve to TOOL FILL position.
NOTICE
Do not use with quick-set materials. They can
harden inside the unit and hose.
ti11670a
ti14876a